These bushings replace the staked factory rubber bushings with Superpro Polyurethane Bushings that are built to last and are properly engineered to increase performance.  The high-end polyurethane design eliminates the parasitic spring rate caused by staked bushings and increase service life. These bushings also provide more positive front arm location during spirited driving. 

The set has Two Offset bushings to correct pulling to one side and or crossmember misalignment or to correct caster angle.  You will need to determine which way the correction will need to go prior and during installation which may require additional alignment time.

Set includes 2-Bushing sets for to replace both bushings

includes grease

a shop press is strongly suggested for ease of install. Its pretty much manditory don't try to do this without one.

 

Install:

The bushing sits at the back of the front LCA which is held on by two bolts into the chassis and one bolt through that is an extension of the arm.

You will need to remove both undercovers and the side bracket bolt that is attached to the #2 bushing bracket.

Remove the two bolts holding the bearing bracket (one with nut) and 2 side rail bracket 

Remove the rear nut that holds the bracket to the LCA.

Remove rear bushing bracket, this may require deflection of the front arm bushing.  If too difficult you will need to remove the entire arm, sway bar and shock absorber. Contact FIGS is this is the case.

With a shop press, remove the old bushing.

Press the new bushing into the aluminum retaining bracket.  Keep in mind that you will press in to correct the alignment condition and offset the rear mount.  Use this to adjust the caster angle when out of spec.  This may require iteration since the bearing presses in.  Its best to spot check the alignmet while determining the location of the offset.  For uniform caster angle you will need to look at the alignment sheet.  mount goes out to increase and inward to decrease.

Reinstall rear nut to hold bushing in place but not to final torque. 

Reinstall 2 bolts plus nut  and 2 bolts of side bracket.   Long bolt through side rail bracket Torque to 204Nm/ 150ft-lbs, short bolt with nut 86Nm/63ft-lbs side rail bolts 50Nm/37ft-lbs

verify clean cyling with suspension by loading and unloading.  While suspension is loaded, apply final torque to through post nut. Torque to 113Nm/ 83ft-lbs

You done!

FREE SHIPPING IN US

Gen 2IS ISx50 Front Lower Arm Rear Mount #2 Polyurethane Bushing Double Offset

  • Product Code: G2IS-FRLCA_DO-SP3692K
  • Availability: In Stock
  • $210.00


Related Products

FIGS MEGA Arms GEN 2 IS / IS-F "RACE VERSION" V2

FIGS MEGA Arms GEN 2 IS / IS-F "RACE VERSION" V2

VERSION 2 now shipping.  TECH DATA CNC machined 1018 steel end fittings. Formed steel c..

$685.00 $875.00

SPC MASTER BUSHING Install Tool Kit

SPC MASTER BUSHING Install Tool Kit

Includes cups and threads to drive in just about any bushing imaginable.  We found it a great asse..

$639.00 $1,249.97

SPC Ball Joint Service Kit 40920

SPC Ball Joint Service Kit 40920

This is a ball joint service tool that seems to be just perfect for pressing out the lower knuckle..

$104.00 $204.47